ETE - European Train Enthusiasts

Allmänt om H0
Användarvisningsbild
AlexanderEhn
Inlägg: 1153
Blev medlem: 2017-07-11, 23:47
Kontakt:

ETE - European Train Enthusiasts

Inlägg av AlexanderEhn »

Hej!

HIttade detta färska klippet på en stor YT-kanal om brukar handla om teknik och ”makers”.

Detta handla om den amerikanska föreningen European Train Enthusiasts som bygger moduler med europeiskt förebild.

https://youtu.be/l7-bZbePQKE


De verkar att en egen standard för Märklin med fungerande luftledning.

Deras modulstandard finns här: https://www.ete.org/module-specifications

Och deras sida är www.ete.org
Pågående byggprojekt just nu:
"Kombihamnen", blir ingen hamn, men väl en kombiterminal i N-skala med svensk förebild Byggtråd här!
"Glassfabriken" blir en industrimodul med genomgående linje, N-Re.
Användarvisningsbild
AlexanderEhn
Inlägg: 1153
Blev medlem: 2017-07-11, 23:47
Kontakt:

Re: ETE - European Train Enthusiasts

Inlägg av AlexanderEhn »

Saxat från modulstandarden:
https://www.ete.org/images/article_imag ... ATIONS.pdf
ETE MODULE SPECIFICATIONS BRIEF HISTORY
Modular model railroading has become an important Special Interest Group (SIG) within ETE. In 1977 Sacramento Chapter member Ken Blair and others pioneered the way for the specifications you are about to read. Without their inspiration, there would likely not be the interest you see today. In 1992 Bay Area member Dave Pryor spearheaded the drive for updated standards and modules. As of the end of 1996, within ETE, there were 18 completed modules with the standards presented below and with an equal number of older modules which are track compatible, not counting and additional 6 modules in some state of construction. All three Chapters, The Sacramento, Bay Area and the San Diego Chapters have corner modules allowing a wide range of configuration setups.
If you have an interest to becoming involved in this aspect of ETE please join us or contact Dave Pryor via the ETE PO Box. The remainder of these specifications will be presented in serial fashion in future issues of the EXPRESS and on the ETE Web site. Once the complete specifications have been published, the entire set will be available separately for a nominal fee from the ETE office. Please note that the wonderful illustrations of Tobias Giles are presented 100% of their original scale. - ed.
INTRODUCTION
At long last we have gotten around to writing updated module standards for ETE modules. The original standards were developed by the Sacramento Chapter module group and have served well for a number of years. A big reason for the success of these standards is the fact that since ETE is not a "Märklin" only or a DC only club, the standards work equally well for both model railroad systems. One of the major goals of updating the standards was to utilize new and future developments in model railroading, as well as to remain compatible with the existing modules. We believe this goal was achieved when the first two new modules built with these standards were joined together with the older modules and run successfully at RailFair in Roseville, California in November of 1992.
Pågående byggprojekt just nu:
"Kombihamnen", blir ingen hamn, men väl en kombiterminal i N-skala med svensk förebild Byggtråd här!
"Glassfabriken" blir en industrimodul med genomgående linje, N-Re.
Skriv svar

Återgå till "Allmänt H0"